マイクロスイッチ — 位置表示機能付きバルブリミットスイッチボックス（NAMUR）

製品説明

Automation only works if you can verify it. This リミットスイッチボックス tells you — and your control system — whether a valve is actually open or closed. It mounts on top of the actuator and houses mechanical limit switches that trip as the valve reaches each end position, sending an electrical signal back to the control room.

If a valve fails to reach its position, the switch does not send its signal, and your system can raise an alarm before the fault causes a problem. That makes it a component you rely on for process safety, not just convenience.

What It Does

• Position feedback: confirms open or closed status to the control room for remote monitoring.
• Safety interlocks: lets the system block an action — like starting a pump — until a valve is in the right position.
• Fault detection: a missing signal flags a valve that is stuck or has failed to move.

主な仕様

Why NAMUR Mounting Matters

Because the box follows the NAMUR standard, it is not tied to one actuator brand. The same switch box drops onto any NAMUR-compatible pneumatic or electric actuator, so you can standardize on one position-feedback part across a plant instead of stocking a different unit for every actuator.

使用場所

• Control rooms — remote monitoring of valve status across the plant.
• Safety interlocks — confirming valves are closed before maintenance starts.
• Automated lines — verifying each valve reached its commanded position.

Related Automation Parts

よくある質問

What does a valve limit switch box do?

It reports the valve’s position. Mechanical switches inside trip when the valve reaches its open or closed end position and send an electrical signal to your control system, so you know the valve’s status without standing next to it.

Is it NAMUR standard?

Yes. It mounts to the NAMUR standard on top of the actuator, so it fits any NAMUR-compatible pneumatic or electric actuator rather than one specific brand.

What type of switches does it use?

Mechanical limit switches. They trip on contact as the valve reaches each end position.

Why is position feedback important?

Automation assumes a valve moved when commanded. The switch box verifies it actually did. If the signal is missing, the control system can raise an alarm or hold an interlock before a mis-positioned valve causes a problem.

Which actuators does it fit?

Any NAMUR-compatible actuator. Tell us the actuator you are using so we can confirm the fit.

価格を確認するにはどうすればよいですか？

Send us your actuator details and the quantity. We reply to every inquiry within 24 hours.

お見積り依頼 — 24時間以内に返信いたします →